Update via RS232

Update codec_name_arial16bold_001 via RS232

 Top  Previous  Next

-  updates the codec_name_arial12_001 firmware via the RS232/Com port connection.

 

Dialog of Update via RS232:
 

updaters232001

 

Requirements:

·RS232 control
·codec_name_arial12_001 update file (*.upd) must be available

 

The current update file can be downloaded from Mayah website www.mayah.com, or can be acquired from support@mayah.com.

 

Warning:

If your codec_name_arial12_002 system firmware is earlier than 1.1.0.44, you must update to system software version 1.1.0.44 first. The system software version can be checked at menu item Status/codec_name_arial12green_001 Software Versions.
The update file for system software version 1.1.0.44 can be acquired from support@mayah.com.
Ignoring this warning can result in the update corrupting the Flash card inside the codec_name_arial12bold_001!

 

Steps to execute an RS232 update:

·Click on OK
·A dialog for selecting a codec_name_arial12_001 update file opens
·Start the update by selecting the update file
·Update runs automatically
·When the Update finishes, CODEC_NAME_ARIAL12_001 reboots automatically, to apply the firmware.

 

Hint:

RS232 update can be speeded up by increasing the RS232 remote control baud rate to 115,200, using File/Remote Settings (manual).

 

Duration time of RS232 update:

·Remote baud rate of 38,400: Approximately 18 minutes
·Remote baud rate of 115,200: Approximately 6 minutes

 

Note:

Since data transfer using RS-232 is not ‘secure’ sometimes it might sometimes be necessary to repeat the update, and thus is NOT THE RECOMMENDED METHOD. If there is an opportunity, use IP control.